Charge Amplifier - Model- 4001B

Charge Amplifier - Model- 4001B " This equipment is a micro- charge amplifier that amplifies charge signals virtually ranging from DC to 50 kHz. It is best suited for use in conjunction with a piezoelectric pressure sensor" . " Simple, easy- to- use instrument engineered with emphasis on basic performance" . " Discharge time constants selectable between LONG and SHORT" . " Built- in output calibration signal ( supplied from the power supply unit) " . " Compatible with various types of sensors, such as vibration, pressure, and force, as long as they are of the charge output type" . " Ready for concurrent use with the charge amplifier Model- 4035" . Specifications: Measuring Range : 10.0- 99.9pC/ UNIT: 1, 2, 5, 10, 20, 50, 100UNIT/ VOLT Range Accuracy : With ± 1.5% ( at 80Hz) Frequency Response : Range 10- 100 ; DC- 50KHz ± 5% : Range 5 ; DC- 40KHz ± 5% : Range 2 ; DC- 20KHz ± 5% : Range 1 ; DC- 10KHz ± 5% Time Constant : Short: Range × 0.1sec( Registance109© ) : Long : Range × 1000sec( Registance1013© min.) Cut Off : ( 0.16/ TC) Hz ( Low Frequency) Linearity : ± 0.1% Noise Level : 0.1pC RMS max. Drift : ± 0.03pC/ S max.( Use DC Balance) Reset Error : ± 0.5pC max. Charge Input Max. : ± 100, 000pC( Through Rate 5000pC/ ¼ s) AC Output : ± 10V max. or ± 5mA max. Output Impedance : 100© Output Cal Signal : 0- 10V DC ( Use Power Unit) Over Load Lamp : Go on when output voltage ± 10.5V Temperature Humidity : 0- 50° C, 80% RH max. Power : Charge Amp Unit: ± 15VDC 20mA max. : Use Power Supply Unit: AC100V± 10V Weight : Charge Amp Unit: 310g/ CH : Power Supply Unit: MODEL- 4001- 10: 800g : 4CH Case: MODEL- 4035- 21: 970g. Distributor agent menjual service repair jasa perbaikan alat, Online monitoring, condition monitoring, Oil analysis, Borescope, Vibration Analyzer, dst. Jakarta - Indonesia Phone : 021-29563045 ( hunting) Hp : 08156141954 Pin BB : 284152F7